TubeInspect is featured in

the July/Aug edition of

Tube & Pipe Journal

Click here to read article

TubeInspect offers better GR&R (Gage Repeatability and Reproducibility), faster cycle times and is much easier to run than conventional measurement systems.  Because they identify problems more quickly, efficiency is improved throughout your production, TubeInspect is easier and faster for operators.

Reasons to invest in the TubeInspect System

Faster Feedback.  TubeInspect provides faster feedback after the first part is made on a bender.  Comparing the time required to set up and run a part on an articulating arm, the TubeInspect will save between 25% to 75%.

First piece setup time. There are many setup costs that go beyond the operator's cost per hour.  Typically there is more than one person working on a setup and machine downtime affects the productivity of the entrie plant.  Automating the feedback to the bender allows for faster setup times, fewer errors in setup.

TubeInspect Speed Reduces Set-up Time

TubeInspect Accuracy and Repeatability

• TubeInspect repeatability is usually several times higher than conventional systems
• The loading of the TubeInspect system consists of placing the tube on the TubeInspect light table. There is no influence from the operator choosing where to measure points.
•  Reduced variability in measurement process provides better production control and makes it easier to stay within manufacturing tolerances.

Statistical Process Control

• TubeInspect is SPC capable. SPC is possible, even on short runs.
• Since measurement is faster and easier, bender performance can be monitored for trends.  This will allow you to know the performance of your different benders to help you choose the best bender for the job.

Automation

• Total automation can be accomplished with the addition of a Robot holding the tube in the measurement range of the TubeInspect system.  The robot does not even need to release the tube while it is being measured.

More Complete Data

• TubeInspect provides complete data through the bend area.
• TubeInspect can measure bend-in-bend tubes which do not have straight sections between bends.
• TubeInspect can measure free-form tubes, 180-degree bends, and small bends.
• TubeInspect will provide overall tube length and by using clip-on adapters will provide data on brackets or other features.

Reliability

Operators Measure Parts More Easily

"The justification for a TubeInspect is that it makes every aspect of your business better.  Allowing you to make a higher quality product faster.  It helps make all of your equipment become fater and more accurate."

TubeInspect has no moving parts. 

Cameras are permanently mounted on rigid steel supports and are enclosed in a robust housing. 

The light table base is covered by a tough polycarbonate layer.