TubeInspect is featured in

the July/Aug edition of

Tube & Pipe Journal

Click here to read article

TubeInspect Adapters  allow measurement of tubes with any geometry

TubeInspect  Adapters make measurements possible of unique tube geometries that can not be measured by the standard TubeInspect configuration.  An adapter is an auxiliary tool to measure additional features.  TubeInspect Adapters fit directly at tube ends while the software calculates the reduction offset generated by the adapter

Holes and Holders

Straight on and elbow adapters

7-point Position and axis adapters

Special Ends

Connection adapters

• Used for screw mounts at tube ends. e.g. brake lines.

• The software reduces the length of adapters.

Straight On Adapters

Elbow Adapters

• For measurment of hidden ends.

• Automatic calculation of the tube end point by measuring the end of the adapter

• Measurement of an additional  bending point

• Automatic calculation of the tube end point by measuring the adapter bending point

• Used for measurement of holes, holders and special ends.

• Adapters consist of  7-point target, whose  3D-coordinates are measured .

• A pre-defined reference position and direction is used for the correction

• Results are displayed in a graphic and table

• Can be used for merging overlapping measurements of a tube with a long straight segment. e.g. brake tubes

• The software can connect multiple measurements using the information of the adapter.

• The adapter is visible in both measurements.

• The fixing of the adapter is held steady along a long straight line during the measurements.